Pointing brick slips, cladding and brick tiles

Pointing brick slips has never been so straightforward

The PointMaster tool is an ideal tool for pointing brick slips and brick cladding tiles. The regular joint sizes found on these products allow the PointMaster to be used in a continuous sliding motion, filling the mortar joints on the first pass at a truely unbelievable speed.

In tests carried out 10 square metres of completed pointing can easily be completed in an hour (including time to stike and finish the joints). Time taken to complete the job is reduced - profitability is increased.

Filling the tool is fast and there is much less waste material to clear-up afterwards, when compared to traditional methods.

Video: Pointing regular joints at up to 10 metre² per hour

In this short video the PointMaster is being used to infill a half-metre-square brick tile panel. You can clearly see how fast and accurate it is to use. Also note how quickly the tool can be refilled once empty. It takes just seconds!

The mortar is a hand mixed, 3:1 regular cement mortar mix with soft building sand, with the correct ammount of plasticiser added following the manufacturer's measure. No other additives are used.

Other applications for Point Master

The tool is suitable for most applications using regular cement mortar, lime mortar and grout for flooring. It works with most common mix ratios, and is fine with mortar colourant and other mortar additives. The links below show projects and short videos of some examples of uses for Point Master. Just click an image.